Rena MACH 5 Guia de Resolução de Problemas descarregar pdf (Página 30)

SECTION 2

INSTALLING THE PRINTER

Procedure (Installing the Printhead):

This procedure assumes that you are installing a Printhead Cartridge into a printer that does NOT have a

Printhead Cartridge installed. If your printer already has a Printhead Cartridge installed, and you wish to

replace the Printhead Cartridge; please refer to the section titled “Replacing the Printhead Cartridge”.

1. Plug in the printer. Turn the printer’s Main Power Switch ON; then press the control panel’s ON/OFF

button. Wait about 45 seconds for the print engine to power-up (ON/OFF button will illuminate).

2. Open the Top Cover.

3. If the Printhead Latch [2] is closed; press the “Printhead Latch

Release” button [1]; as shown.

Use a non-metallic item (example: plastic pen) to reach

through the hole and lightly press the button.

The printer will run a routine and then the Printhead Latch [2]

will release so it can be opened.

WARNING! If the printhead latch fails to release do not force

the latch open. Severe damage will result.

Tip: You can perform this same function from your computer

by clicking “Printhead Release” from the “Services” tab of the

“M Series Driver” properties, or the “User Interface” screen of

the M Series “Toolbox” utility.

4. Open the Printhead Latch all the way to fully retract the Ink Couplings

[3].

WARNING! Do not force the latch open or severe damage will result.

Use the “Printhead Latch Release” button.

5. Be sure that all protective packaging materials [4] are removed from

the Ink Coupling [3] areas.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 108 109

Sem comentários

Rena MACH 5 Guia de Resolução de Problemas Página 30